Kukko 2-Arm Bearing Puller with Side Clamp 204-2 vendor_TAGARNO 118-piece set ∙ M6 to

118-piece set ∙ M6 to M14

Sutton Tools Extension Shanks fit all 7/16″ hex shank bits

and GWP< 1

035% of full scale General Specifications Instrument setup recall Last used on power-up Environmental Operating temperature -10°C to +45°C

Kukko 2-Arm Bearing Puller with Side Clamp 204-2 vendor_TAGARNO 118-piece set ∙ M6 toOverview The 2 arm "Cobra" bearing puller with side clamp is used to pull off particularly tight ball bearings, bearing rings and workpieces. It can be used to loosen any component that sits on a shaft and is freely accessible from the outside. Thanks to the clamp, the contact pressure of the puller legs is increased many times over. When the clamp is tightened, the sharp claws of the puller legs grip under the part to be pulled off and loosen it even