Inline Fabrication - Mounting bracket for Factory Dillon tray. Fits XL 650 & 750 Expander Mandrel The tapered design ensures that

The tapered design ensures that the Collet securely closes on the case rim without pulling the case back

PROPRIETARY PRO-TUFF COATED RODS HAVE A BUILT IN COATING TO THE ROD ITSELF ALONG WITH EXCLUSIVE (PTC)

Note: After treating gun allow solvent contained in the oil to evaporate for 10 minutes before placing gun in any airtight container such as a gun case

Hornady V-Max bullet design

Inline Fabrication - Mounting bracket for Factory Dillon tray. Fits XL 650 & 750 Expander Mandrel The tapered design ensures thatDesigned to be used with or with out an Ultramount riser system if you want to use the Dillon tray Mounts to the left front foot of the Dillon 650 or can mount straight to your bench top. It's angled by a few degrees to keep them near the front of the tray. Also works with the new Dillon bulletfeeder support arm (Dillon tray not included) (Dillon Precision part number #22214 or #22215 ) OR works perfectly with InLine Fab's lower cost 3D tray with side